DHT22 temperature and humidity sensor

The DHT22 combined temperature and relative humidity sensor provides a simple and low-cost solution.

To differentiate between the two readings, the DHT22 makes use of a simple protocol on a single data pin which is best interpreted by using existing library code. The instructions below show how to connect the DHT22 up to your Particle Argon, and take you through the process of finding and including the right library in your application code using the Web IDE.

This example is based on the Adafruit version that is provided with the library code, and the Photon Maker Kit tutorial linked in the box above.

First, set up the hardware connections as shown below:

Next, go to the Particle Web IDE and paste the code below into the editor.

Give your file a name and save it using the folder icon in the navigation panel.

#define DHTPIN 2            // what pin we're connected to
#define DHTTYPE DHT22       // DHT 22 (AM2302)
#define INTERVAL 10000       // number of milliseconds between checks
                            // Reading temperature or humidity takes about 250 milliseconds!
                            // Sensor readings may also be up to 2 seconds 'old' (its a 
                            // very slow sensor)

// Connect pin 1 (on the left) of the sensor to +3.3V
// Connect pin 2 of the sensor to whatever your DHTPIN is
// Connect pin 4 (on the right) of the sensor to GROUND
// Connect a 10K resistor from pin 2 (data) to pin 1 (power) of the sensor

// Initialise an object to represent the DHT22 sensor
DHT dht(DHTPIN, DHTTYPE);

// Declare globa variables for the readings and the time last checked
double temp;
double hum;
unsigned long lastCheck = 0;

// Function that can be called from the Particle console
void readSensor() {
    hum = dht.getHumidity();
    temp = dht.getTempCelcius();
}

// Callback function to allow the Particle console access to readSensor()
int checkHandler(String command) {
readSensor();
return 1;
}

void setup() {
    dht.begin();

    // Declare variables that can be seen in the Particle console
    Particle.variable("temperature", temp);
    Particle.variable("humidity", hum);
    Particle.function("readSensor", checkHandler);
}

void loop() {
    if (lastCheck + INTERVAL < millis()) {
        lastCheck = millis();
        readSensor();

        // Check if any reads failed and exit early (to try again).
        if (isnan(hum) || isnan(temp)) {
            Serial.println("Failed to read from DHT sensor!");
            return;
        }

        Particle.publish("temperature", String(temp), PRIVATE);
        Particle.publish("humidity", String(hum), PRIVATE);
    }
}

Now click on the Libraries icon in the navigation panel and search for dht as shown below.

Choose the library called Adafruit_DHT. This will display the library - click the button labelled Include in project.

In the next step of the process, select your file from the ones displayed and click Confirm when prompted.

Flash the code to your device, and then go to the Particle console.

You should see events being published every ten seconds, and in addition, you should be able to get the values of the two variables declared in the code and call the readSensor() function to generate ad-hoc events.